Warning: Because of the strong adhesive securing the display, minimal clearance for inserting your tools, and high heat required, there"s a good chance of accidentally damaging the display when removing it. If you intend to re-use the display, take serious care when heating and inserting tools to separate the display from the rest of the device.

You are watching: Moto z2 play headphone jack


*

*

Heat the edges of your Motorola Moto Z2 Play screen for two to three minutes with a heat gun. You adjust the heat gun to 85 degrees centigrade, and be careful not to hold the heat gun on one position for too long; to avoid damaging, or "hotspotting" the LCD. The screen should be very warm, but not painful, to the touch. Reheat as necessary.


If screen is cracked put strong adhesive tape across the screen in order to avoid breaking the screen further and receiving cuts.


*

*
*


If you don’t have a suction cup, wedge a spudger or a small plastic card under the screen and lift slowly.


Disconnect the ribbon cable, located at the bottom right of the phone, by pulling out and back with tweezers.


If screen doesn"t detach, go back to step 7 and 8 to make sure the bar is unlocked and ribbon connector is fully detached.


Remove the seven silver 2.6 mm T3 Torx screws on the black battery cable cover at the bottom of the phone with a screwdriver by turning counterclockwise.


Remove the single black 3.5 mm T3 Torx screw on the black battery cable cover at the bottom of the phone with a screwdriver by turning counterclockwise.

See more: What Is The Product Of 8 And 54 ? Find The Product Using Multiplication Property


Cal Poly, Team S19-G5, Livingston Winter 2018 Member of Cal Poly, Team S19-G5, Livingston Winter 2018

CPSU-LIVINGSTON-W18S19G5

4 Members

22 Guides authored


Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.


©2021 rwandachamber.org — Licensed under Creative Commons — Privacy — Terms — Accessibility