My 200 S is only getting heat on drivers side and cool air on passenger side. I changed the blend door actuator behind the gloves box. Still having actually the very same issue. Need help please.Thanks brandon powell


You are watching: Chrysler 200 no heat on passenger side

*

Hey Brandon,This is a typical problem, the driver next of the mix door actuators has actually gone out, here is a guide to to walk you with the actions of instead of it and also diagrams on i beg your pardon one to replace in your car int the diagrams bbelow.https://www.rwandachamber.org/articles/replace-blend-door-motorCheck out the diagrams (Below). Please let us recognize if you need anything rather to obtain the trouble fixed.
*

*

*

*

here is the just image gives us, as soon as you have it eliminated turn the heater on and work the blend door by hand to check out what the does to make certain you have actually the best onePlease let me know.
Hello, right here are much more diagrams to aid you see where the places of the mix door actuators are located. Check out the diagrams (Below)
Yep we can help, please short article your new question here, you have to be logged in.https://www.rwandachamber.org/questions/newCheers, Ken
gotten rid of re-circulation actuator, removed blend door actuator and manually close up door the left next heater blend door. Regular heat circulation from chauffeurs side vents. Observed setting door actuator rotation once adjusting mode control knob. Tho no heat flow from passenger side vents. Behavior to relocate wire harness and connector to regulate module then hot air started flowing indigenous passenger side vents.
Not sure what girlfriend are in search of in an answer. It appears you have successfully found that the problem is a bad connection or a negative wire. Let me know exactly what is necessary so I have the right to help.
the is correct. If the mix air door isn't working, that is most most likely the problem. Save in mind, i am assuming girlfriend have twin climate control. There will certainly be 2 blend doors, one because that each side.


See more: Quick Guide: Does Solder Conduct Electricity ? A Beginner'S Guide To Soldering

good afternoon,Since over there is no actuator because that each side, that is no an actuator issue.Do you have gauges that can read the high and low side of the system? I must see those reading with the engine off and with it running with the A/C on.https://www.rwandachamber.org/articles/car-air-conditioner-not-working-or-is-weakhttps://www.rwandachamber.org/articles/re-charge-an-air-conditioner-systemRoy